Before You Start . . .

Tools

For most installations, the basic tools you will need are:

SCREWDRIVERS

Electrical

• WASHER

Refer to Serial plate for specific electrical requirements. For more detailed information, refer to Section on Washer Electrical Requirements.

WRENCH

SOCKET

WRENCH

9 / 1

6 "

PLIERS

•ELECTRIC DRYER

Dryer needs a 3 or 4 wire 120/240 or 120/208 Volt, 60 Hertz, AC single Phase electrical supply. For more detailed information, refer to Section on Electric

Dryer Electrical Requirements.

•GAS DRYER

Dryer needs a 120 Volt, 60 Hertz, polarized 3-slot effectively grounded receptacle. For more detailed information, refer to Section on Gas Dryer Electrical

Requirements.

LEVEL

TEFLON TAPE

DUCT TAPE

D074IE1G

Water

Washer needs two standard 3/4 inch (19.1 mm) water supply faucets with a pressure between 20-120 pounds per square inch (138 to 827 kPa). For more detailed information, refer to Section on Water Supply

Requirements.

Exhaust

Use rigid metal duct and exhaust the dryer to the outside by the shortest route possible.

NOTE: 208 Volt heating element is available (as optional equipment at extra cost).

Gas

Dryer is equipped for Natural Gas with a 3/8" NPT gas supply connection. For more detailed information, refer to Section on Gas Requirements.

Location

Place the dryer on a solid floor with an adequate air supply. For more detailed information, refer to Section on Location Requirements.

H092IE1A

NOTE: For more detailed information, refer to Section on Dryer Exhaust Requirements.

8

504509