Step 8:

Position and Level the Unit

Place unit in position on a clean, firm and reasonably level floor. Installing the unit on any type of carpeting is not recommended.

Loosen 9/16" locknuts and adjust the leveling legs until the unit does not rock and is level from side-to-side and front-to-back. Hand tighten locknuts against unit base and then securely tighten locknuts with 9/16" deep well socket wrench. If the locknuts are not tight, the unit will move out of positon during operation.

NOTE: Level must rest on raise portion of top panel. See illustration.

Remove rubber feet from accessories bag and place on all four leveling legs.

CAUTION

DO NOT slide unit more than four feet across floor if the leveling legs have been extended, as legs and base could become damaged.

W184

CAUTION

Use of the dispenser drawer or washer or dryer doors as handles in the transportation of the unit may cause damage to the dispenser or doors.

W185

NOTE: For further assistance, refer to Section on Location Requirements.

LEVEL

WASHER

BASE

LEVELING

LEG

RUBBER

CUP

LOCKNUT

H234IE1A

14

504509