Installing the Unit

Step 1: Position Unit Near Installation Area

Move unit so that it is within 4 ft. of the desired area of installation.

CAUTION

Washer and dryer are not designed to be operated as separated, side-by-side units.

W187

SWD443N

SWD443N

Figure 3

Step 2: Connect Water Inlet Hoses

NOTE: Refer to section on Water Supply Requirements before connecting water inlet hoses.

Remove the four plain rubber washers from accessories bag, and install them according to Figure 4.

Turn on the water supply faucets and flush the lines for approximately two minutes to remove any foreign materials that could clog the screens in the water mixing valve.

Installation

NOTE: When installing in newly constructed or renovated building, it is very important to flush the lines since build-up may have occurred during construction.

IMPORTANT: Thread hose couplings onto valve connections finger-tight, then approximately

1/4 turn with pliers. DO NOT cross thread or overtighten couplings.

Turn water on and check for leaks. If leaks are found, retighten the hose couplings. Continue tightening and rechecking until no leaks are found.

1

2

H091I

H091I

1Rubber Washer (Plain)

2Inlet Hose

Figure 4

2 1

WATER MIXING

VALVE

4

3

 

 

SWD548N

SWD548N

1Water Supply Faucets

2Cold Water Connection

3Hot Water Connection

4Water Inlet Hoses

Figure 5

800937

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

9