3.Use the three screws from the envelope located in the cylinder to attach the power cord wires to the terminal block.

2

1

3

D286I

1“L1” Terminal

2Neutral Terminal

3“L2” Terminal

Figure 29

4.Tighten all screws and reinstall access cover removed in step 1.

IMPORTANT: Failure to tighten these screws firmly may result in wire failure at the terminal block.

5.Secure the strain relief to the power cord, or wires, where they enter the dryer cabinet.

6.Check the continuity of the ground connection before plugging the cord into an outlet. Use an acceptable indicating device connected to the center grounding pin of the plug and the green screw on the back of cabinet.

7.Reinstall access cover and screw.

Installation

Four-Wire Plug

1

2

3

4

D815I

1Typical Four-Wire Receptacle

2Power Cord – Not supplied with dryer (Four-Wire)

3Strain Relief Nut

4Strain Relief

Figure 30

1. Remove access cover from rear of dryer.

D695I

Figure 31

800937

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

23