Installation
Before You Start
Tools
For most installations, the basic tools you will need are:
1 | 2 | 3 |
4
7 | 6 | 5 |
|
D814I
1Wrench
2Screwdrivers
3Pliers
4Socket Wrench
5Teflon Tape
6Level
7Duct Tape
Figure 1
Water
Washer needs two standard 19.1 mm (3/4 inch) water supply faucets with a pressure between 138 and
827 kPa (20 to 120 pounds per square inch). For more detailed information, refer to section on Water Supply Requirements.
Location
Place the unit on a solid floor with an adequate air supply. For more detailed information, refer to section on Location Requirements.
Exhaust
Use rigid metal duct and exhaust the dryer to the outside by the shortest route possible.
NOTE: For more detailed information, refer to section on Dryer Exhaust Requirements.
H311I
Figure 2
Electrical
●WASHER
Refer to serial plate for specific electrical requirements. For more detailed information, refer to section on Washer Electrical Requirements.
●DRYER
Refer to serial plate for specific electrical requirements.
Dryer needs a 2 wire plus earthing, 230 Volt,
60 Hertz, 30 Amp,
12 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | 802031 |