Allied International Home Security System Voltage above +45 V may damage the optical coupler

Camera interfaces

OutVCC	Resistor value
5 V	1 kΩ
12 V	2.4 kΩ
24 V	4.7 kΩ

Figure 36: OutVCC (PIKE)

Note PIKE

•Voltage above +45 V may damage the optical coupler.

•The output connection is different to the AVT Dolphin series to achieve higher output swing.

•Depending on the voltage applied at OutVCC and the type of input which you want to drive, it may be neces- sary to switch an external resistor in series between GPOut1...4 and ground. See Figure 34: Output schemat- ics with external resistors R (pin no. from camera I/O connector) (PIKE) on page 57.

•Typical delay is not more than 40 µs.

Parameter	Sym-	Value	Condition
	bol
Delay time	td	1.00 µs
Rise time	tr	2.60 µs	OutVCC = 5 V
Storage	ts	48.00 µs	Resistor value = 1 kΩ
time
Fall time	tf	400.00 µs

Figure 37: Output schematics: switching times (PIKE)

Note	For information on output features (IntEna, Fval, Busy) and
	configuration via registers see Technical Manuals.

Hardware Installation Guide V2.0.0

58