Allied International Home Security System manual Pike and Stingray family, Level Description

Camera interfaces

PIKE and STINGRAY family

Pin		Signal		Direction	Level	Description
1		External GND			GND for	External Ground for RS232
					RS232 and	and external power
					ext. power
2		ExtPower			+8...+36 V DC	Power Supply
3		CameraOut4		Out	Open emitter	Camera Output 4 (GPOut4)
						default: -
4		CameraIn1		In	CMOS / TTL	Camera Input 1 (GPIn1)
					8-36 V	default: Trigger
5		CameraOut3		Out	Open emitter	Camera Output 3 (GPOut3)
						default: Busy
6		CameraOut1		Out	Open emitter	Camera Output 1 (GPOut1)
						default: IntEna
7		CameraIn GND		In	Common GND	Camera Common Input
					for inputs	Ground (In GND)
8		RxD_RS232		In	RS232	Terminal Receive Data
9		TxD_RS232		Out	RS232	Terminal Transmit Data
10		CameraOutPower		In	Common VCC	Camera Output Power
					for outputs	for digital outputs (OutVCC)
					max. 35 V DC
11		CameraIn2		In	CMOS/TTL	Camera Input 2 (GPIn2)
					8-36 V	default: -
12		CameraOut2		Out	Open emitter	Camera Output 2 (GPOut2)
						default: Follow CameraIn2
	Figure 20: Camera I/O connector pin assignment
	Note		GP = General Purpose

Note	Pin 1 is not internally bridged with pin 7 to avoid ground
	noise being induced in the camera and to prevent ground
	loops. Use pin 1 only if you want to power the camera by
	HIROSE or to connect to the serial interface of the camera in
	combination with pin 8 and 9.

Hardware Installation Guide V2.0.0

45