Allied Telesis AR400 series manual Hub or Layer 2 Switch

30 AR400 Series Router

1.Connect the PC to a router switch port.

The PC can be connected directly, or through your LAN.

To connect the PC directly to the router, use a straight-through Ethernet cable to connect an Ethernet card on the PC to any one of the router’s switch ports. See the following figure.

		PC
Router
					POWER	ON
		4	2
PIC BAY
					100-240 VAC	OFF
ADSL	5	3	1	ASYN0	50/60 Hz
					2.1 A
	Switch Ports

To connect via a LAN, use an Ethernet cable to connect the router’s switch port(s) to the device(s) on the LAN. Select the LAN PC from which you wish to configure the router. The PC should be in the same subnet as the part of the LAN that contains the router. For example, the PC could be connected to a hub or Layer 2 switch that is directly connected to one of the router’s switch ports. See the following figure.

Hub or Layer 2 Switch					PC
ON
	10BASE-T/100BASE-TX SWITCH PORTS
	4	3	2	1
OFF
POWER
Router
					POWER	ON
		4	2
PIC BAY
					100-240 VAC	OFF
ADSL	5	3	1	ASYN0	50/60 Hz
					2.1 A
	Switch Ports

613-000313 Rev C