AT-8900, AT-9900, AT-9900s Series Switches

ALL COUNTRIES: Install product in accordance with local and National Electrical Codes.

WARNING: For centralized DC power connection, install only in a restricted access area.

A tray cable is required to connect the power source if the unit is powered by centralized DC power. The tray cable must be UL listed Type TC tray cable and rated at 600 V and 90 degrees C, with three conductors, minimum 12 AWG.

WARNING: Only trained and qualified personnel are allowed to install or replace this equipment.

WARNING: As a safety precaution, a 15 Amp circuit breaker should be installed at the supply end of the cable to be used with this LAN equipment.

Always connect the wiring to the LAN equipment first before connecting the wiring to the breaker. To avoid the danger of physical injury from electrical shock, do not work with HOT feeds. Always be sure that the breaker is in the Off position before connecting the wiring to the breaker.

WARNING: Do not strip more than the recommended amount of wire. Stripping more than the recommended amount can create a safety hazard by leaving exposed wire on the terminal block after installation.

WARNING: When installing this equipment, always ensure that the frame ground connection is installed first and disconnected last.

WARNING: “Safety Hazard” - Check to see if there are any exposed copper strands coming from the installed wires. When this installation is done correctly, there should be no exposed copper wire strands extending from the terminal block. Any exposed wiring can conduct harmful levels of electricity to persons touching the wires.

DC versions of this system will work with a positive grounded or negative grounded DC system.

Sicherheit

WARNUNG: Bei Verwendung zu Hause kann dieses Produkt Funkstörungen hervorrufen. In diesem Fall müßte der Anwender angemessene Gegenmaßnahmen ergreifen.

WARNUNG Laserprodukt der Klasse 1.

WARNUNG Nicht direkt in den Strahl blicken.

ACHTUNG: GEFÄHRLICHE SPANNUNG

Das Gehäuse nicht öffnen. Das Gerät enthält keine vom Benutzer wartbaren Teile. Das Gerät steht unter Hochspannung und darf nur von qualifiziertem technischem Personal geöffnet werden.

18

Page 18
Image 18
Allied Telesis AT-9900s manual Sicherheit, Achtung Gefährliche Spannung