64 | Rapier Switch User Guide |
AppleTalk
The advanced feature licence
To create an AppleTalk port (interface) associated with the admin VLAN, use the command:
ADD APPLE PORT INTERFACE=vlan11
The command:
SHOW APPLE PORT
displays information about the ports configured for AppleTalk (Figure 21 on page 64).
Figure 21: Example output from the SHOW APPLE PORT command.
Appletalk | Port Details |
|
Port Number | 1 | |
Interface | vlan11 | |
ifIndex | .................. | 1 |
Node ID | .................. | 217 |
Network | Number | 22 |
Network | Range Start | 22 |
Network | Range End | 22 |
State | ACTIVE | |
Seed | NO | |
Seed Network Start | 0 | |
Seed Network End | 0 | |
Hint | YES | |
Hint Node ID | 179 | |
Hint Network | 22 | |
Default | Zone | - |
Zone List is Empty |
| |
Resource Reservation Protocol (RSVP)
The advanced feature licence
The Resource Reservation Protocol (RSVP) enables the receiver of a traffic flow to make the resource reservations necessary to ensure that the receiver obtains the desired QoS for the traffic flow.
RSVP is disabled by default. To enable RSVP, use the command:
ENABLE RSVP
Each IP interface that is to receive and process RSVP messages and accept reservation requests must be enabled. To enable RSVP on the admin VLAN, use the command:
ENABLE RSVP INTERFACE=vlan11
Rapier Switch Software Release 2.2.1
