Allied Telesis C613-02013-00 manual Triggers

58		Rapier Switch User Guide
	Table 13: Parameters in the output of the SHOW IP IGMP command.
	Parameter	Meaning
	Status	The status of IGMP; one of “Enabled” or “Disabled”.
	Default Query Interval	The default interval at which Host Membership Queries are
		sent.
	Default Timeout Interval	The default interval after which entries will be removed
		from the group database, if no Host Membership Report is
		received.
	Group List	A list of multicast group memberships for this interface.
	Group	The group multicast address.
	Last Adv.	The last host to advertise the membership report.
	Refresh time	The time interval (in seconds) until the membership group
		will be deleted if it does not receive another membership
		report before then.

Triggers

The Trigger Facility can be used to automatically run specified command scripts when particular triggers are activated. When a trigger is activated by an event, global parameters and parameters specific to the event are passed to the script that is run. For a full description of the Trigger Facility, see the Trigger Facility chapter in the Rapier Switch Software Reference.

The switch can generate triggers to activate scripts when a fibre uplink port loses or gains coherent light. To create or modify a switch trigger, use the commands:

CREATE TRIGGER=trigger-idMODULE=SWITCH EVENT={LIGHTOFFLIGHTON} PORT=port [AFTER=hh:mm] [BEFORE=hh:mm] [DATE=dateDAYS=day-list] [NAME=name] [REPEAT={YESNOONCEFOREVERcount}] [SCRIPT=filename...] [STATE={ENABLEDDISABLED}] [TEST={YESNOONOFF}]

SET TRIGGER=trigger-idPORTS={port-listALL} [AFTER=hh:mm] [BEFORE=hh:mm] [DATE=dateDAYS=day-list] [NAME=name] [REPEAT={YESNOONCEFOREVERcount}] [TEST={YESNOONOFF}]

The following sections list the events that may be specified for the EVENT parameter, the parameters that may be specified as module-specific-parameters, and the arguments passed to the script activated by the trigger.

Event LINKDOWN

Description The port link specified by the PORT parameter has just gone down.

Parameters The following command parameter(s) must be specified in the CREATE/SET TRIGGER commands:

ParameterDescription

PORT=port The port on which the event will activate the trigger.

Rapier Switch Software Release 2.2.1 C613-02013-00 Rev A