Allied Telesis GS900/5E manual Installing the Switch in a Rack

Chapter 2: Installation

Installing the Switch in a Rack

Perform the following procedure to install the switch in a standard 19-inch rack. If you are not installing the switch in a rack, go to the next procedure.

1.Place the unit upside down on a level, secure surface.

2.Using a flat-head screwdriver, remove the self-adhesive rubber feet from the bottom of the switch, as shown in Figure 9.

Figure 9. Removing the Feet

3.Turn the switch over.

4.Attach the two rackmounting brackets (provided) to the sides of the switch using the eight flathead Phillips screws (provided), as illustrated in Figure 10.

605

Figure 10. Attaching Rackmounting Brackets

32