5.Apply power to the switch by plugging the AC/DC power adapter into an AC power outlet, the plug the DC connector to the power receptacle of the switch.
Warning
The power cord is used as a disconnection device. To
6.Verify that the POWER LED is green. If the LED is OFF, refer to “Troubleshooting” on page 37 for instructions.
Note
The switch perform a
7.Power ON the
8.Check that all the SPD/LINK/ACT LEDs are green. If any of the LEDs are OFF, refer to “Troubleshooting” on page 37 for instructions.
The switch is now ready for use.
31
