14Patch Release Note
PCR: 40431 Module: SWMXLevel: 2
When the IPV6 accelerator card was present but disabled, the switch was not transmitting
PCR: 40433 Module: VLANLevel: 2
When the nested VLAN feature was disabled using the disable feature command, the switch did not remove, from software and hardware, all of the nested VLAN’s associated ports, protocols and subnets as well as the nested vlans. This issue has been resolved.
PCR: 40440 Module: CLASSIFIERLevel: 3
For those classifiers that specified the IP protocol as a match criterion, the IP protocol number was being stored and displayed in a configuration file as a hexadecimal value rather than a decimal value. This issue has been resolved.
PCR: 40441 Module: IPG, VRRPLevel: 4
If VRRP was enabled and a reset ip command was issued followed by a disable vrrp command, then the device would still reply to pings, even though the device was no longer the VRRP master. Duplicate echo replies were seen on the device sending the pings. This issue has been resolved.
PCR: 40446 Module: DHCPLevel: 2
In certain situations, if a DHCP client used a DHCP relay agent to request IP addresses from the switch acting as the DHCP server on a different subnet, it was not be able to renew the IP address allocated to it. This issue has been resolved.
PCR: 40453 Module: IPGLevel: 2
Particular IP packets (unicast destination IP, but multicast destination MAC) could result in a memory leak, which in some cases could cause the device to stop responding to the command line. This issue has been resolved.
PCR: 40454 Module: SWNPLevel: 3
The enable/disable switch accelerator commands could be executed even though no IPv6 accelerator card was installed. This issue has been resolved.
PCR: 40458 Module: IPGLevel: 2
The switch was accepting network RIP packets from foreign subnets. This issue has been resolved.
Patch
