20Patch Release Note
PCR: 40318 | Module: IPV6 | Level: 2 |
The next hop of an IPv6 RIPng Response message was not assigned with a link local address when an invalid next hop was specified in the prefix field of the route table entry. This issue has been resolved.
PCR: 40322 | Module: TM | Level: 3 |
An error message was not returned if an unavailable interface was specified for the enable test interface command. This issue has been resolved.
PCR: 40334 Module: VLAN | Level: 2 |
A dynamic VLAN created by GVRP should contain a tagged port, but it did not. This issue has been resolved.
PCR: 40338 Module: VLAN | Level: 2 |
When an untagged port was added to a
PCR: 40341 Module: SWMX, SWI
Hardware filtering has been enhanced so that the traffic class can be remapped using classifiers and hardware filtering. This can increase the chance of packets that match the classifier reaching the CPU because they are transmitted to the CPU on a different queue and DMA channel. To configure this type of filtering, use the command add switch hwfilter action=setl2qos.
PCR: 40342 | Module: SWI | Level: 2 |
It was not possible to set a QoS policy to a port if the corresponding classifier with IPv6 parameters was changed. This issue has been resolved.
PCR: 40343 Module: IPV6, VLAN | Level: 2 |
If there were more than one port connected on the same IPv6 interface, traffic stopped if a cable was unplugged from the egress port of the switch and then plugged into a different port. This issue has been resolved.
PCR: 40348 Module: VLAN | Level: 2 |
STP restarted when GVRP sent a Join message for a newly created dynamic
VLAN. This issue has been resolved.
Patch
