10 | Patch Release Note |
PCR: 40498 | Module: OSPF | Level: 3 |
When a virtual link end point is no longer reachable, the virtual interface is not brought down, and the virtual neighbour is not removed. This issue has been resolved.
PCR: 40515 | Module: QoS | Level: 3 |
Setting switch enhanced mode to “none” in order to disable QoS counters did not disable the QoS counters properly. A debug error message was shown when attempting to view the traffic class counters. This debug error message has now been removed and an appropriate error message is now displayed.
PCR: 40525 Module: SWI, SWX | Level: 3 |
When MIB counters relating to packet flows reached their maximum possible value (0xFFFFFFFF), they should have returned to 0, and counted up from 0 again. However, they were remaining stuck at 0xFFFFFFFF.
This issue has been resolved, so that the counters will correctly roll over from 0xFFFFFFFF to 0 and start counting up again.
Level 4
No issues.
Enhancements
PCR: 40511 | Module: RSTP |
The RSTP module has been enhanced to detect simple loop scenarios downstream of an RSTP enabled edge port. If a loop is detected, the port is placed into a Backup/Discarding/LoopbackDisabled state. In this state, all packets are discarded. The port transitions to a Designated/Discarding state after 3 x helloPeriod. If the loop still exists, the Backup/Discarding/ LoopbackDisabled state is repeated.
PCR: 40521 Module: TACACS+
The new command show tacplus has been added. This command shows the module status, number of servers, and number of logged in users.
Patch
