Patch | 3 |
PCR: 40596 Module: SWMX | Level: 2 |
When STP is enabled, when frames with a multicast destination MAC address were sent, a loop was observed within the network. This issue has been resolved.
PCR: 40601 Module: SWMX | Level: 2 |
In network configurations with multiple paths to neighbours on an interface, if the interface changed state from up to down, then up again, the interface route may have been erroneously deleted by a route update. This issue has been resolved.
PCR: 40619 | Module: IPG | Level: 2 |
The valid and preferred parameters were incorrectly added to the dynamic set ipv6 prefix configuration. The default onlink and autonomous parameters were also being included. This issue has been resolved.
Level 3
PCR: 40589 | Module: IPG | Level: 3 |
The counter parameter did not exist in the show igmpsnooping command.
This issue has been resolved.
PCR: 40603 Module: SWI, SWMX | Level: 3 |
An error message is now shown if the user tries to assign more than the allowable number of traffic class (or default traffic class) entries to active QOS policies.
PCR: 40606 Module: VLAN | Level: 3 |
When a Core port was added to a nested VLAN, its Ingress Filtering attribute was set to be On and Acceptable Frame Type was set to be Admit Only VLAN tagged Frames. If the port was deleted from that VLAN, its Ingress Filtering attribute must be set to Off and Acceptable Frame Type must be set to Admit All Frames, however, the attributes were not changed when the port was deleted from the nested VLAN. This issue has been resolved.
PCR: 40617 | Module: TTY | Level: 3 |
The manager prompt did not appear when using a telnet session until the [Enter] key was pressed several times. This issue has been resolved.
PCR: 40618 | Module: SWI | Level: 3 |
An FTP server located on a private interface of a firewall with NAT enabled may have had its
Patch
