Patch | 13 |
PCR: 02088 | Module: SWI | Network affecting: No |
Port mirroring on the Rapier 48 and 48i was not operating correctly because
Destination Lookup Failure (DLF) frames were sent from the mirror port.
This issue has been resolved.
PCR: 02095 | Module: SWI | Network affecting: No |
The software routing performance of the Rapier 48 and Rapier 48i has been enhanced.
PCR: 02101 | Module: SWI | Network affecting: No |
The layer 3 hardware table was not sorted properly when it contained a very wide range of IP addresses (eg. 10.0.0.1 - 205.33.3.1). This caused a small number of packets to be routed by software rather than hardware. This issue has been resolved.
PCR: 02104 | Module: TRG | Network affecting: No |
The periodic and time trigger counts were incrementing by two instead of one on each update. This issue has been resolved.
PCR: 02105 | Module: FFS | Network affecting: No |
An error occurred when the FLASH write driver was required to write values that were not
Features in
Patch file details for Patch
Table 6: Patch file details for Patch
Base Software Release File | |
|
|
Patch Release Date | |
|
|
Compressed Patch File Name | |
|
|
Compressed Patch File Size | 336952 bytes |
|
|
Patch
PCR: 02092 | Module: SWI | Network affecting: No |
The SET SWITCH L3 FILT command overwrote existing Layer 3 filters. If multiple filter entries existed, this command changed the most recent entry, rather than the one specified. These issues have been resolved. Also, the SET SWITCH L3 FILT command now allows for creation of multiple filter entries with the SETPRIORITY and SETTOS parameters. The Layer 3 filter protocol match now has no limit.
Patch