Allied Telesis R800 Series manual

Models: R800 Series

1 30
Download 30 pages 8.55 Kb
Page 9
Image 9

Patch 86222-22 For Rapier Switches and AR800 Series Modular Switching Routers

9

PCR: 02263

Module: VRRP

Network affecting: No

The virtual MAC address was used as the source MAC for all packets forwarded on an interface associated with a Virtual Router (VR). This was confusing when multiple VRs were defined over the same interface because only one virtual MAC address was ever used. The other virtual MAC addresses (for the other VR's) were only used if the source IP address matched the VR’s IP address. To avoid this confusion, the system MAC address is now always used unless the source IP address of the packet is the same as the VR’s IP address.

PCR: 02264

Module: PIM, DVMRP, SWI

Network affecting: No

PIM or DVMRP failed to see any data if IGMP snooping was on and DVMRP or PIM was enabled after the data stream had reached the router/ switch. This issue has been resolved.

PCR: 02265

Module: FIREWALL

Network affecting: No

MAC address lists were not working with Firewall rules. This issue has been resolved.

PCR: 02268

Module: FIREWALL

Network affecting: No

HTTP requests from a fixed IP address were erroneously reported as a host scan attack in the Firewall deny queue. This issue has been resolved.

PCR: 02269

Module: DUART, TM

Network affecting: No

Under certain circumstances, the Asyn Loopback Test failed. This issue has been resolved.

PCR: 02274

Module: TPAD

Network affecting: No

ARL message interrupts have been re-enabled after a software table rebuild to fix synchronisation of the software forwarding database with the hardware table.

PCR: 02275

Module: OSPF

Network affecting: No

Some routes were not added into the OSPF route list, and therefore were not added into the IP route table. This issue has been resolved.

PCR: 02276

Module: FIREWALL

Network affecting: No

The CREATE CONFIG command did not save the SOURCEPORT parameter to the configuration file when the low value of the source port range was set to zero. This issue has been resolved.

PCR: 02287

Module: IPG

Network affecting: No

Existing IGMP groups were not deleted when IGMP was disabled globally or on the associated interface. This gave the groups very high timeout values. This issue has been resolved.

PCR: 02299

Module: VRRP

Network affecting: No

If a packet with a destination IP address equal to a VRRP IP address was received when the router didn’t own the IP address, (because it didn’t have an interface with that IP address) the router incorrectly tried to forward the packet and send an ICMP “redirect” message to the source. Now, if such a packet is received, it will be discarded and an ICMP “host unreachable” message will be sent to the source.

Patch 86222-22 for Software Release 2.2.2 C613-10319-00 REV U

Page 9
Image 9
Allied Telesis R800 Series manual