18 | Patch Release Note |
PCR: 01275 | Module: FIREWALL | Network affecting: No |
The firewall was incorrectly forwarding multicast packets originating from a private address in cases where a matching route was defined. This issue has been resolved.
PCR: 01276 | Module: SWI | Network affecting: No |
When the speed of one or more switch ports was forced to a half duplex setting and the ports were then added to a trunk group configured for full duplex operation, the port settings were not overridden by the trunk group speed setting. The trunk group speed setting will now take precedence over the port speed setting.
PCR: 01287 | Module: OSPF | Network affecting: No |
Configuring IP route filters did not stop flooding of AS external LSAs to neigbours at startup. The result was that the neigbour received the AS LSAs and added the corresponding routes into its own routing table. However, after some time (e.g. 1 hour), the AS external LSAs in the neigbour’s database disappeared, but the corresponding routes were still in its routing table. This issue has been resolved.
PCR: 01289 | Module: VRRP | Network affecting: No |
The checksum in VRRP advertisements was not being calculated correctly. The calculation was not compatible with the RFC. This issue has been resolved.
PCR: 01290 | Module: PPP | Network affecting: No |
When PPP was running over Ethernet to a client from another vendor, the
Maximum Transmission Unit value for the link was not adjusted from the
PPP default of 1500 to 1492. This issue has been resolved.
PCR: 01291 | Module: IPG(IGMP) | Network affecting: No |
IGMP did not send the Start Up Query, and the Other Querier Present Timer did not change the Time Out value accordingly if Query Interval was changed. IGMP did not notify other registered parties (PIM and DVMRP) when a port was deleted from a membership group. IGMP reported a membership leave to other parties while it was still waiting for a reply to a group specific query from a leaving member. These issues have been resolved.
PCR: 02003 | Module: FIREWALL | Network affecting: No |
The timeout value for ICMP session entries in the firewall can now be adjusted via the OTHERTIMEOUT parameter of the SET FIRE POLICY command. Note: if the value for OTHERTIMEOUT is set to more than 10 minutes the timeout used for ICMP sessions will default to 10 minutes.
PCR: 02007 Module: DHCP | Network affecting: No |
When a DHCP server received a DHCP DISCOVERY packet passed by a relay agent, requesting an IP address that did not belong to the subnet the client and the relay agent were attached to, it offered the requested address if it was available. The DHCP server will now only offer an IP address from the subnet that connects the client and the relay agent.
Patch
