Allied Telesis R800 Series manual Support for multi-homed interfaces has been added

Patch 86222-22 For Rapier Switches and AR800 Series Modular Switching Routers 3

PCR 02192	Module: IP	Network affecting: No
The source IP address in DVMRP prune and graft messages was incorrect.
This issue has been resolved.
PCR: 02241	Module: FIREWALL	Network affecting: No

Firewall subnet NAT rules were not working correctly from the private to the public side of the firewall. Traffic from the public to private side (destined for subnet NAT) was discarded. These issues have been resolved. ICMP traffic no longer causes a RADIUS lookup for access authentication, but is now checked by ICMP handlers for attacks and eligibility. If the ICMP traffic matches a NAT rule, NAT will occur on inbound and outbound traffic. HTTP 1.0 requests sometimes caused the firewall HTTP proxy to close prematurely. Cached TCP sessions were sometimes not hit correctly. These issues have been resolved.

PCR: 02359 Module: IPG Network affecting: No

When an IP Multihomed interface was used as an OSPF interface, neighbour relationships were only established if the IP interface for OSPF was added first in the configuration. Now, OSPF establishes neighbour relationships regardless of the IP Multihomed interface configuration order.

PCR: 02395 Module: VRRP, TRG Network affecting: No

The SHOW VRRP command now shows the number of trigger activations for the Upmaster and Downmaster triggers.

PCR: 02396 Module: DHCP Network affecting: No

DHCP RENEW request messages are now unicast (as defined in the RFC), not broadcast.

PCR 02400	Module: CORE, FFS, FILE,	Network affecting: No
	INSTALL, SCR

If a problem occurred with NVS, some critical files were lost. As a result, the equipment was forced to load only boot ROM software at boot time. This patch combined with the new version of the boot ROM software (pr1-1.2.0 for the AR700 series) resolves this issue.

PCR 02408 Module: SWI Network affecting: No

The EPORT parameter in the SHOW SWITCH L3FILTER ENTRY command was displaying incorrectly after an issue was resolved in PCR02374. The command now displays correctly.

PCR: 02427 Module: DHCP Network affecting: No

DHCP entry reclaim checks are now delayed by 10 seconds if the entry is unroutable because the interface is not up.

PCR: 02463 Module: DVMRP, IPG Network affecting: No

Support for multi-homed interfaces has been added.

PCR 02465 Module: TTY Network affecting: No

Under some circumstances a fatal error occurred if a large amount of data was pasted onto the command line. This issue has been resolved.

Patch 86222-22 for Software Release 2.2.2 C613-10319-00 REV U