22 Patch Release Note
Patch SB251-13 for Software Release 2.5.1
C613-10361-00 REV M
The action of the MAJOR and MINOR relays
does not presently match the illustration
located alongside their connections.
This issue has been resolved by reversing
the action of the relays in software to match
the illustration shown on the right.
Please check that your alarm relays are still
appropriately connected.
The SET TRACE PORT command was not functioning correctly. Also, the
SHOW CONFIG DYNAMIC PING command was producing an incorrect
output format. These issues have been resolved.
The TRACE command was not working when using an IPv6 link-local
address. This issue has been resolved.
A memory leak occurred when some IPSEC processes failed. This issue has
been resolved.
Parallel forwarding PIM neighbours were not always sending PIM Assert
messages following a neighbour re-boot. This was causing the transmission
of duplicate multicast data. This issue has been resolved.
PIM4 and PIM6 were not sending Hello packets if the HELLOINTERVAL
was not a multiple of 10. This is set with the ADD PIM INTERFACE, ADD
PIM6 INTERFACE, SET PIM INTERFACE, and SET PIM6 INTERFACE
commands. This issue has been resolved.
If a DVMRP interface was deleted and then added again, DVMRP routes
associated with this interface were not reactivated. This issue has been
resolved.
If the RP candidate advertising time was set to a non-default value with the
ADVINTERVAL parameter in the SET PIM command, the hold time in the
message was not being updated correctly. This issue has been resolved.
The output from the SHOW SWITCH PORT COUNTER command was
showing incorrect values for packets greater than 1519 bytes. This issue has
been resolved.
PCR: 03209 MODULE: ALARM Level: 1
PCR: 03210 Module: PING Level: 4
PCR: 03212 Module: IPV6 Level: 3
PCR: 03213 Module: IPSEC Level: 3
PCR: 03214 Module: PIM Level: 2
PCR: 03216 Module: PIM, PIM6 Level: 2
PCR: 03217 Module: DVMRP Level: 2
PCR: 03222 Module: PIM, PIM6 Level: 2
PCR: 03223 Module: SWI Level: 2
ALARM RELAYS
MINOR ALARM
N/O N/C
COMMON
MAJOR ALARM
N/O N/C
COMMON
, 1A
, 0.5A
12 VDC
48 VDC