15-EN
Receiving RDS Regional (Local)
Stations
1Press and hold the INTLZ button for at least 2
seconds to activate the setting mode.
2Press the f UP button repeatedly to select
"REG. (REGIONAL)" Each press of the f UP
button scrolls the modes as shown:
NOTE
If you press the DN g button the display scrolls in
reverse sequence.
3Press the TUNE button to turn on or off the
REGIONAL mode.
In the REGIONAL OFF mode, the unit
automatically keeps receiving the related local
RDS station.
4Press and hold the INTLZ button for at least 2
seconds to deactivate the setting mode.
Receiving Traffic Information
1Press the F button. The FUNC indicator will
illuminate.
2Press the F2 (T.INF) button to activate the Traffic
Information mode.
3Press the DN g or f UP button to select
your desired traffic information station. When a
traffic information station is tuned in, the TP
indicator lights up.
Traffic information is heard only when it is being
broadcast. If traffic information is not being
broadcast, the unit is set in the standby mode.
When a traffic information broadcast begins, the
unit automatically receives it and the display
shows "TRF-INFO" for 5 seconds, then returns
to the previous display.
When traffic information broadcast is over, the
unit will automatically set in the standby mode.
4Press the F button to activate the normal mode.
The FUNC indicator will turn off.
NOTES
•If the traffic information broadcast signal falls below a
certain level, the unit remains in the receiving mode
for 1 minute. If the signal remains below a certain
level for over 1 minute, the "T.INFO" indicator blinks.
•If you do not want to listen to the traffic information
being received, lightly press the F2 button to skip that
traffic information message. The T.INFO mode will
remain in the ON position to receive the next traffic
information message.
•If the volume level is changed while receiving traffic
information, the changed volume level will be
memorized. When traffic information is received next
time, the volume level will be automatically adjusted
to the level memorized.
•In the T.INFO mode, the SEEK tuning selects only the
TP stations.
PTY (Programme Type) Tuning
1Press the F button. The FUNC indicator will
illuminate.
2Press the F3 (PTY) button to activate the PTY
mode. The Programme Type of the station being
currently received will be displayed for 5
seconds.
If there is no receivable PTY broadcast, "NO
PTY" will be displayed for 5 seconds.
NOTE
If no button is pressed within 5 seconds after pressing the
PTY button, the PTY mode will be automatically
cancelled.
3Press the DN g and f UP buttons within 5
seconds after activating the PTY mode to
choose the desired programme type while the
PTY (programme type) is being displayed. Each
press scrolls the programme type by one.
→ LIGHT M → CLASSICS → OTHER M
4Press the F3 button within 5 seconds after
selecting the programme type to start searching
for a station in the selected programme type.
The chosen programme type indicator blinks
during searching and lights when a station is
found.
If no station is found, "NO PTY" will be displayed
for 5 seconds.
5Press the F button to activate the normal mode.
The FUNC indicator will turn off.
NOTE
Operate the unit while the FUNC indicator is
illuminated.
If no buttons are pressed within 5 seconds, the FUNC
indicator will turn off.
→ FM-LE → REG → PTY31 → AMBER → DIM → SUB → BEEP
D-OUT ← CLOSE ← DEMO ← AUX ← SCR ← MUTE ←