Alpine CDA-7969R owner manual Installation, 29-EN, Removal

Installation

1

	Rubber Cap
	(Included)
Bracket	Hex Bolt
	(Included)

Dashboard

Mounting sleeve (Included)

CDA-7969R

Slide mounting sleeve from main unit (see Removal Procedure below). Slide the mounting sleeve into the dashboard.

No Pressure Here

No Pressure Here

2

Metal Mounting Strap

Screw

∗ Bolt Stud

Hex Nut (M5)

CDA-7969R

When your vehicle has the Bracket, mount the long hex bolt onto the rear panel of the CDA-7969R and put the Rubber Cap on the hex bolt. If your vehicle does not have the Mounting Support, reinforce the head unit with the metal mounting strap (not supplied). Connect all the leads of the CDA-7969R according to details described in the CONNECTIONS section.

NOTE

For the screw ∗, provide a proper screw to the chassis installing location.

3 Slide the CDA-7969R into the dashboard. When the unit is in place, make sure the locking pins are fully seated in the down position. This can be done by pressing firmly in on the unit while pushing the locking pin down with a small screwdriver. This ensures that the unit is properly locked and will not accidentally come out from the dashboard.

Lock pin

Removal

1Use a small screwdriver (or similar tool) to push the locking pins to the "up" position (see above drawing). As each pin is unlocked, gently pull out on the unit to make sure it does not re-lock before unlocking the second pin.

2Pull the unit out, keeping it unlocked as you do so.

<JAPANESE CAR>

Front frame

Screws (M5 ⋅ 8) (Included)

CDA-7969R

Mounting Bracket

29-EN