Alpine CDA-7969R owner manual Multi-Changer Selection, 22-EN

CD Player Operation

SOURCEBAND/T.S.M.

DN g f UP

Searching for Titled Discs/CD Text

If a CD is titled, you can do a search for it. You can also search for CD TEXT discs by title. (To title CDs, refer to "Titling Discs" on page 20.)

1 Press and hold the T.S.M. button for at least 2 seconds. The title blinks in the display.

2 Press the DN g or f UP button to select the desired disc title/CD Text disc.

1 Press the SOURCE button on the CDA-7969R to activate the CD Changer mode.

Alternatively, press the SOURCE button on the Remote Control (RUE-4185) to activate the CD Changer mode. Proceed to Step 3 below to select the desired CD Changer.

CD-CHG
BAND	SOURCE	A.PROC
PROG
BAND		SOURCE

REMOTE CONTROL UNIT RUE-4185

3 Press the T.S.M. button to play the selected disc. The unit will automatically search for the disc and begin play.

NOTES

•This function cannot be performed when using a multi- changer switching device.

•To search for a title from CD TEXT discs, first you need to playback the CD TEXT disc at least once so that it is registered in the unit’s memory.

Multi-Changer Selection

Alpine's Ai-NET system will support up to 6 CD Changers. When operating two or more changers, the KCA-400C (Multi-Changer Switching device) must be used. If you use 1 Switching device, you can connect up to 4 CD Changers. If you use 2 Switching devices, you can connect up to 6 CD Changers.

2 Press the BAND button on the CDA-7969R or the RUE-4185 to activate the Changer Selection mode.

3 The CD Changer Selection mode remains active for 3 seconds after Step 2 is performed. Press the BAND button until the desired CD Changer indicator appears on the display.

NOTE

If the selected CD Changer is not connected, the display will show "NO CHANGER."

Alternatively press the BAND button on the Remote Control until the desired changer indicator appears on the display.

4 To operate the selected changer, see "CD Operation" section.

22-EN