Motorola DSR405 manual Installation Settings

Options

Installation Settings

Tune in Satellite Signal. This option allows you to see the strength of the signal your antenna is receiving.

Set VCR Code. Some models will allow you to automatically control your VCR so it will record programs. You will have to enter the code of your VCR in your receiver. You have two ways to do so: you can enter it directly, using your remote

control; or you can enter it by scanning through codes on your receiver and selecting the right code.

Enter VCR Code. This option allows you to record the number code for your VCR in your receiver. Look up the code in Section 3.0 of this manual, enter the numbers via your remote control, and perform a test.

Scan for VCR Code. This option allows you to enter the code by scanning through a list of VCRs and then choosing the one you want.

Set Remote Control Address. This option allows you to control up to four receivers in a centralized area with one or more remote controls. Each receiver requires a separate address. The default address is 000.

On the front panel of your receiver press the Menu button.

•Choose Options.

•Choose option 6 (Change System Settings).

•Choose option 3 (Installation Settings).

•On the Installation Settings menu, choose option 2 (Set Remote Control Address). Now follow the instructions on the Remote Control Address screen.

•If you have four receivers, you will have to change the addresses on three of them: they will have address of 000, 001, 002, and 003.

To program your remote control for each receiver, hold down the SAT key on the remote control until the light flashes. Once the light begins to flash enter the desired address (000, 001, 002, or 003).

DSR405 User Guide 61