With the automatic adjustment function, the operation described below is performed. Adjustments are completed in about 10 seconds.
Time correction.
“END” is displayed for about 15 seconds and the automatic adjustment is completed.
•If the microphone does not pick up the sound or the speakers are not working or are connected or wired improperly, the automatic adjustments are not performed and a error message is displayed.
Check the various speakers then perform the automatic adjustments again.
AUTO TCR
ERROR
8 Check that the automatic adjustment has been completed (that “END” has been displayed for about 15 seconds), then get back into the vehicle and disconnect the microphone.
9 To store, follow the procedure described at “Storing settings in the memory” (page 28).
NOTES
•Automatic measurements cannot be made unless the microphone is connected (error display). To perform time correction automatically, be sure to connect the included microphone first.
•Before making automatic measurements, press the AUTO TCR button to cancel it.
•No other operations can be performed while measurements are being made.
•Measurements will differ according to the position in which the microphone is mounted.
•Note that using for extended periods of time without turning on the engine may wear down the battery.
•Automatic measurements cannot be made for the subwoofer. Make the subwoofer setting manually. Refer to “Performing time correction manually (TCR)/Switching the phase” (page 8).
•When the speaker is set to the “OFF” mode, the TCR for that speaker cannot be adjusted. Refer to “Setting the speakers” (page 4).
•After making the settings, we recommend storing them in the memory. For instructions, see page 28.
