![11.[OFF]](/images/new-backgrounds/124745/12474527x1.webp)
11.[OFF]
This command disables one or more outputs for a single card or a group of cards.
SINGLE CARD OPERATION
Command Format: [OFFmCnUi]
m= Output (m = # from 1 to max outputs) Cn = Card ID (n = # from 1 to max slots)
Ui = Unit ID (i = # from 0 to 9)
Example:
Card 5 has Output 1 ON. The following commands may be used to turn OFF the output.
1) | [OFF1C5]: | Turns OFF Output 1 only. |
2) | [OFF23C5]: | Turns OFF Outputs 2 and 3. |
3) | [OFFC5]: | Turns OFF all outputs. |
GROUP OPERATION
Command Format: [OFFmGkUi]
This command disables output "m" for each card in group "k" of unit "i".
m= Output (m = # from 1 to max outputs) Gk = Group ID (k = # from
Ui = Unit ID (i = # from
Example:
1.[OFF1G1]: Turns OFF Output 1 for each card in group 1.
2.[OFFG1]: Turns OFF all outputs for each card in group 1.
PATH OPERATION
Command Format: [OFFmCnUiP]
This command will set the path for the output, but it is not active until the switch command, [SW], is executed. Commands ending in "P" are not executed immediately. The path for outputs on multiple cards or the same card may be preloaded.
m= Output (m = # from 1 to max outputs) Cn = Card ID (n = # from 1 to max slots)
Ui = Unit ID (i = # from 0 to 9)
P= Path
Example:
There are two
7.Disable Output 1 of card 6 and Output 3 of card 7 simultaneously using the following commands:
[OFF1C6P]
[OFF3C7P]
[SW]
If "F" is included, use the [OFFmCnPF] command or the [OFFmCnFP] command.
FEEDBACK OPERATION
Command Format: [OFF…..F]
After processing a command, an OK or ER will be returned as feedback if "F" is included at the end of a command string.
Example:
[OFF1C2F]: if path is not set
[OFF1C2PF]: if path is set
12. […S] – SAVE
This command will save the configuration
command being sent in memory. When sending the command [I1O1C4S], after reset or power up, Input 1 will be connected to Output 1 on C4. This command only saves the Input 1 to Output 1 connection above. In order to save all the current settings, use the [CnS] command.
13. […F] – FEEDBACK
After processing a command, an OK or ER will be returned as feedback if "F" is included at the end of a command string.
13 |
