![10.[ON]](/images/new-backgrounds/124745/12474525x1.webp)
Command Format: [SIGOmCnUi]
m= Output (m = # from 1 to max outputs) Cn = Card ID (n = # from 1 to max slots)
Ui = Unit ID (i = # from 0 to 9)
Example 1:
The card in slot #4 has Input 1 connected to Output 1 and Output 1 is turned ON. Verify the output signal is detected by sending the command [SIGO1C4] and receiving feedback equal to "1".
10.[ON]
This command will enable one or more outputs for a single card, or a group of cards.
SINGLE CARD OPERATION
Command Format: [ONmCnUi]
m= Output (m = # from 1 to max outputs) Cn = Card ID (n = # from 1 to max slots)
Ui = Unit ID (i = # from 0 to 9)
Example:
There is an
1)[ON1C5]: Turns ON only Output 1 of the
2)[ON12C5]: Turns ON Outputs 1 and 2.
3)[ONC5]: Turns ON all Outputs.
GROUP OPERATION Command Format: [ONmGkUi]
This command enables Output "m" for each card in group "k" of unit "i".
m= Output (m = # from 1 to max outputs) Gk = Group number (k = # from
Ui = Unit ID (i = # from
Example:
[ON1G1]: Turns ON Output 1 for each card in Group 1. See the GROUP commands for a detailed explanation.
PATH OPERATION
This command will set the path for the output, but it is not active until the switch command, [SW], is executed. Commands ending in "P" are not executed immediately. The path for outputs on multiple cards or the same card may be preloaded.
Command Format: [ONmCnUiP]
m= Output (m = # from 1 to max outputs) Cn = Card ID (n = slot # from 1 to max slots)
Ui = Unit ID (i = # from 0 to 9)
P= Path
Example:
There are two
7.Enable Output 1 of card 6 and Output 3 of card 7 simultaneously. To do this, send the following commands:
[ON1C6P]
[ON3C7P]
[SW]
If "F" is included, use the [ONmCnPF] command or the [ONmCnFP] command.
FEEDBACK OPERATION
After processing a command, an OK or ER will be returned as feedback if "F" is included at the end of a command string.
Command Format: [ON…..F]
Example:
[ON1C2F]: if path is not set
[ON1C2PF]: if path is set
12 |
