Altinex MT105-120/121 manual Clrg, Clm, C Receives status of the card 3 CnS Save card settings

MULTI-TASKER™

25.[CLRG]

This command clears the members for a single group or for all groups. The clear command restores the cards to default settings and is the equivalent to sending the [CLR] command to each individual card.

NOTE: Since this command is sending the [CLR] command to its group members, each card will display its own reset message, if any.

Command Format: [CLRGkUi]

Gk = Group ID (k = # from 1-8, or [ for all)

Ui = Unit ID (i = # from 0-9)

Example:

1)To clear group 1 of Unit ID 0, send the [CLRG1] command. This command clears the members for the specified group only.

2)To clear all groups of Unit ID 1, send the [CLRG[U1] command.

26.[CLM]

This command removes the members in a group and leaves the group empty. It is equivalent to sending the [RMGkUi] command without card references.

Command Format: [CLMGkUi]

Gk = Group number (k = # from 1-8)

Ui = Unit ID (i = # from 0-9)

Example:

Group 5 of Unit ID 1 contains the cards in slots 1, 2 and 19. Read the member data for group 5 of Unit ID 1. Send the command [RDG5U1] and receive the following feedback:

G1=C1C2C19

Now, clear group 5 by sending the command [CLMG5U1]. Reread the member data as above and note the following feedback:

G1=EMPTY

7.3SUMMARY OF COMMANDS Card Commands

1)[VER] Receives software version

2)[C] Receives status of the card

3)[CnS] Save card settings

4)[?] Show status/ general information

5)[STA] Enable/disable auto feedback

6)[SDL] Read Sync Delay settings

7)[SDLm] Set Sync Delay settings

8)[SIGI] Input signal detect

9)[SIGO] Output signal detect

10)[ON] Turns on one or more outputs for a single card or a group of cards

11)[OFF] Turns off one or more outputs for a single card or a group of cards

12)[…S] Save the command configuration

13)[…F] Provides feedback upon sending

14)[…P] Sets the path, preload for [SW]

15)[SW] Switch preloaded output buffer

16)[IO] Connects inputs to the outputs

17)[CLR] Reset card to default values

18)[MAT] Define the matrix size

19)[TEST] Test internal memory IC's

20)[HELP] Display available commands Group Commands

21)[WR] Groups multiple cards

22)[RMC] Remove members from a group

23)[RMG] Remove one or more groups

24)[RDG] Displays group members

25)[CLRG] Clears group members

26)[CLM] Removes an entire group

400-0362-003 17