Operating instructions US
4.2 Starting
Check that the oil level in the oil reservoir(s) (2) is between the MIN. and MAX. markings. The inlet water
NOTE: The system automatically stops after approx. 4 seconds if there is no water consumption. In the event of a power failure or activation of the thermal switch (with subsequent cooling) the system can be restarted from pos. 0.
O |
| |
|
|
|
| 1 | Check oil level |
|
| |
| Start | Turn to „Start“ position |
|
|
position 1 = operation). Watch the pressure gauge (3) to see that pressure is being built up in the system when activating the trigger of the spray handle, on which a spray lance set for high pressure is attached. If pressure does not build, vent the machine as described in section 3.4 Venting.
|
| Check oil level |
| ||||
O |
|
|
| Turn to: |
|
| |
|
|
|
|
|
|
| |
|
|
|
|
| Position 1 | = | Pump no. 1 in operation |
1+2 | 1 |
|
|
| Position 2 | = | Pump no. 2 in operation |
|
|
|
|
| Position 1+2 | = | Pumps no. 1 & 2 in |
operation
2
Ensure that pressure is building in the system by watching the pressure gauge (3). If pressure is not being built, vent the machine as described in section 3.4 Venting.
4.3Operation - automatic start/stop
Always hold the spray lance with both hands!
Always lock the trigger when the machine is not in operation.
Once started, the system will automatically
When the machine is not in use, the trigger should be locked by turning the safety knob (2) into position 0.
12