Maintenance
Warming Drawer
CAUTION
•NEVER store plastic, paper products or flammable materi- als in this drawer. The drawer may become too warm for these items when the oven is in use or the warming drawer is preheated.
•To avoid contact with the warming drawer heating element, pull drawer all the way out to add or remove food.
•Never use oven cleaners to clean the warming drawer.
To remove warming drawer:
1.Empty drawer and pull out until it is fully open.
2.Locate the black triangle lever on each side of the drawer.
3.Press the lever down on the right side and lift the lever up on the left side at the same time. Then pull drawer out another inch.
4.Carefully pull the drawer all the way out holding on to the sides, not the drawer front.
To replace warming drawer:
1.Pull the bearing glides to the front of the chassis glide. (See picture below.)
2.Align the glide on each side of the drawer with the glide slots on the range.
3.Push the drawer into the range until levers “click” (approxi- mately 2”). Pull the drawer open again to seat bearing glides into position. If you do not hear the levers “click” or the bearing glides do not feel seated, remove the drawer and repeat steps 1 through 3. This will minimize possible damage to the bearing glides.
CHASSIS
GLIDE
BEARING
GLIDE 
24
