American Dryer AD-120ES Specifications ADG-120ES ADE-120ES ADS-120ES

SpecificationsADG-120ESADE-120ESADS-120ES

NOTE: ADC RESERVES THE RIGHT TO MAKE CHANGES IN SPECIFICATIONS AT

ANY TIME, WITHOUT NOTICE or OBLIGATION.

NOTE:OPERATING HEIGHT OF STEAM DRYER

is 89 inches (226.1 cm).

EXHAUST

DUCT DIA.DIM.

"A" DIM.

"A"

GAS AND

ELECTRIC

12"

30.5 cm

11-1/4"

28.6

9-1/2"

24.1 cm

STEAM 16"

40.6 cm

22.9 cm

Contents

Main AD-120ES Installation/Operators Manual Retain This Manual In A Safe Place For Future Reference Important AD-78 Page Page Table of Contents SECTION I IMPORTANT INFORMATION IMPORTANT: The dryer must be transported and handled in an upright position at all times. A. RECEIVING and HANDLING B. SAFETY PRECAUTIONS Page 5 SECTION II SPECIFICATIONS / COMPONENT IDENTIFICATION A. SPECIFICATIONS Shaded areas are stated in metric equivalents. Gas Electric Steam Specifications ADG-120ES ADE-120ES ADS-120ES NOTE:OPERATING HEIGHT OF STEAM DRYER is 89 inches (226.1 cm). B. COMPONENT IDENTIFICATION Page SECTION III INSTALLATION PROCEDURES A. LOCATION REQUIREMENTS IMPORTANT: Dryer should be located where a minimum amount of exhaust duct will be necessary. Page IMPORTANT: The dryer must be transported and handled in an upright position at all times. C. DRYER ENCLOSURE REQUIREMENTS D. FRESH AIR SUPPLY E. EXHAUST REQUIREMENTS Page Page Page Page Page Page F. ELECTRICAL INFORMATION ADG-120ES Reversing, 3 (GAS) ADS-120ES Reversing, 3 (STEAM) E ADE-120ES (72 Kw Electric) Reversing, 3 E 24 ADE-120ES (80 Kw Electric) Reversing, 3 E NOTE: A CIRCUIT SERVING EACH DRYER MUST BE PROVIDED. Page G. GAS INFORMATION Type of Gas Type of Gas Page Page Operating Steam Pressure STEAM DAMPER SYSTEM Compresses Air Supply Air Pressure Normal 80 psi Minimum Supply 70 psi Maximum Supply 90 psi Page I. PREPARATION FOR OPERATION NOTE: LINT DRAWER MUST BE ALL THE WAY IN PLACE TO ACTIVATE SAFETY J. PREOPERATIONAL TESTS Page Page K. OPERATING INSTRUCTIONS Page SECTION IV SERVICE/PARTS INFORMATION A. SERVICE B. PARTS SECTION V WARRANTY INFORMATION A. RETURNING WARRANTY CARD(S) B. WARRANTY C. RETURNING WARRANTY PARTS Page SECTION VI ROUTINE MAINTENANCE A. CLEANING Clean the lint drawer/screen every third or fourth load. Page Page SECTION VII TROUBLESHOOTING Page Page Page Page Page TIMER MODELS Page ELECTRIC MODELS STEAM MODELS Page Page SECTION VIII REVERSING TIMER SPIN/DWELL ADJUSTMENTS Timing Legend SECTION X 2. Direct Spark Ignition (DSI) System