4.To remove the lint drawer switch box assembly, remove the two (2) screws inside the lint drawer area that secure the box to the side of the lint coop.
5.Disassemble lint drawer box assembly from the dryer by disconnecting the two (2) harness connectors from the box assembly.
6.Remove the two (2) phillips head screws securing the cover to the switch mounting bracket.
7.Disassemble the switch from the box by removing the two (2) slotted head screws securing the switch to the bracket and disconnect the terminals from the switch.
8.Reverse procedure for reinstalling the lint drawer switch assembly.
9.Reestablish power to the dryer.
G. To Remove and Replace Sensor Bracket and Components
1.Discontinue power to the dryer.
2.Remove the lint drawer, and the control and lint door from the dryer. Follow lint drawer, and control and lint door removal procedures in sections A and B.
3.Pull the front of the sensor bracket forward to remove it from the "S" clips. Pivot bracket downward and assembly will separate from the sensor bracket holder.
4.To disassemble bracket assembly from dryer, disconnect the two (2) harness connectors.
5.To remove the temperature sensor and the connecting harness with its connectors:
A.Disassemble microprocessor sensor probe from the bracket by removing the 1/4"
B.Remove harness connectors by squeezing sides and pushing towards the center of the bracket.
C.Disconnect the two (2) wires from the 170º thermostat.
D.Reverse procedure for installing new sensor probe assembly.
6.To replace the 170º thermostat:
A.Remove the two (2) slotted head screws, washers, and nuts securing the 170º thermostat at the bracket assembly.
B.Reverse procedure for installing new 170º thermostat.
7
