Excessive noise or vibration | American Dryer Corp ADG-60 specification

3.Restriction in exhaust duct work.

T.Dryer is making scraping noise at basket (tumbler) area

1.Check for objects caught in basket (tumbler) wrapper area.

2.Basket (tumbler) is out proper alignment

a.Check gap between the front panel and the basket (tumbler) front set screws may have come loose and basket (tumbler) walked forwards or backwards.

3.Loose or broken basket (tumbler) tie rod.

4.Broken basket (tumbler support).

U.Excessive noise or vibration

1.Dryer is not leveled properly.

2.Impellor (fan) out of balance or broken.

3.Loose basket (tumbler) tie rod.

4.Basket (tumbler) is out of adjustment or adjustment bolts (hardware) are loose.

5.Loose motor or motor mount assembly.

V.Basket (tumbler) turns too fast (as opposed to other baskets [tumblers])

1.Foreign objects caught between basket (tumbler) belt and motor shaft.

W.Computer registers more time than what was inserted (i.e. 99 mins. one coin)

1.Replace optic switch (P/N: 137056)

2.Replace computer board.

33

Image 37

American Dryer Corp ADG-60 Dryer is making scraping noise at basket tumbler area, Excessive noise or vibration

Contents

VAC Phase Retain This Manual In a Safe Place For Future Reference For Your Safety Page Table of Contents Electrical Troubleshooting Section Cleaning Lubrication Adjustments To Remove Lint Drawer To remove gas valve train assemblyTo remove control middle or lint lower door To Remove Control Box To Remove and Replace Lint Drawer Switch AssemblyTo Remove Front Panel To Remove and Replace Sensor Bracket and Components To Remove or Replace Belt Loctite To Remove or Replace Motor Reverse steps 1 through Loctite To Remove or Replace Impellor Fan Belt and Idler Tension Adjustment To Replace Dual Control Microprocessor DMC Computer Fan Belt and Tension Adjustment To Replace Coin Acceptor To Replace Touchpad Keypad Basket Tumbler Alignment Vertical To Replace either Motor Relay Basket Tumbler Alignment Lateral To Replace Basket tumbler or Basket tumbler Support Loctite Important Never strike the shaft directly with a hammer To Replace Basket tumbler Support Pillow Block BearingPage To Replace Basket Tumbler Support Flange Bearing To Replace 330º F Burner Hi-Limit Switch Thermostat To Replace Main Door Switch To Replace Sail SwitchTo Replace Direct Spark Ignition DSI Module BB. To Replace Gas Valve AA. To Replace Ignitor and Probe DD. To Replace Coin Vault Discontinue power to the dryer EE. To Remove Main Door FF. To Install New Main Door GlassGG. To Replace Main Door Gasket HH. To Replace Main Door Hinge No L.E.D. Display Troubleshooting DMC computer L.E.D. display reads dSFL DMC computer L.E.D. display reads Sefl DMC computer L.E.D. display reads Hot If dryer is equipped with optional battery back up Condensation on main door glass Dryer operates, but is taking to long to dry Excessive noise or vibration Dryer is making scraping noise at basket tumbler area No Display Condition Electrical Troubleshooting No Start Condition Motor Doesnt Turn No Heat Condition Gas DOOr Condition DSFL Condition Data Label Technical Information HOW to USE a Manometer Using a Manometer Clcc E.D. Display Codes Fill Diagnostic L.E.D. Display Failure Codes Phase 5 System Diagnostics Phase 5 DMC Computer Relay Output L.E.D. Indicators E.D. Display Indicators DOT Phase 5 DMC Computer Input and Output L.E.D. Indicators WR ADC450162 1- 10/15/98-50