a.Motor air vents clogged with lint.
b.Low voltage to motor.
E.The dryer operates for a few minutes and then stops, DMC computer L.E.D. continues to read cycle in progress, indicator dots are off and dryer can be restarted by pressing selection key
1.Intermittent connection in main door and lint drawer circuit
a.Main door switch or lint drawer switch out of proper adjustment.
b.Loose connection in main door switch or lint drawer switch wiring.
c.Failed main door switch or lint drawer switch.
F.The dryer does not start, and the DMC computer L.E.D. display reads "door"
1.Dual Microprocessor Control (DMC) "door" input L.E.D. is off
a.Main door or lint drawer is not properly closed.
b.Failed main door switch.
c.Failed lint drawer switch.
d.Open circuit (broken wire or termination) in main door switch circuit wiring or lint drawer switch circuit wiring.
e.Failed 24 VAC step down transformer.
2.Dual Microprocessor Control (DMC) "door" input L.E.D. is on
a.Failed Dual Microprocessor Control (DMC) computer.
G.The dryer does not start (COIN MODELS ONLY) coins inserted and the L.E.D. continues to read "FILL" or "Amount to Start" (does not read "PUSH")
1.Coin acceptor is not adjusted properly (housing is not flush with panel) or is dirty with lint.
2.Failed coin acceptor optic switch.
3.Parameter in Program Location 01 (PL01) set incorrectly.
a.Bad coin program should be set for "bCrS" and not "bCLO".
H.DMC computer L.E.D. display reads "dSFL"
1.L.E.D. display consistently reads "dSFL" and will not clear
a.Dual Microprocessor Control (DMC) computer
b.Failed Dual Microprocessor Control (DMC) computer temperature sensor.
c.Broken wire or termination in sensor harness somewhere between the sensor bracket and the Dual Microprocessor Control (DMC) computer.
2.L.E.D. display reads "dSFL" for a short period of time (30 seconds or less) and then returns to the normal stop "FILL" mode.
29
