D. To Remove Control Box
1.Discontinue power to the dryer.
2.Remove the lint drawer and the control door from the dryer. Follow lint drawer, and control and lint door removal procedures in sections A and B.
3.Remove screw located on the bottom
4.Slide out the control box and hang the control box assembly on hinges located on the right side panel, and disconnect the three (3) wiring harnesses (connectors) at the back of the control box.
5.The control box may now be taken out of the dryer completely or depending on the service function to be performed, the box can be attached to the two (2) female hinges on the right side
of the dryer cabinet.
NOTE: If the control box is attached to the dryer cabinet, the three (3) wiring harnesses men- tioned in step #4 do not need to be disconnected.
6.Reverse procedure for reinstalling the control box assembly.
7.Reestablish power to the dryer.
E. To Remove Front Panel
1.Discontinue power to the dryer.
2.Remove the control box assembly. Follow control box removal procedure in section D.
3.If the bottom front panel is being removed, the lower lint door must also be removed.
4.Disconnect the door switch connector from the lint drawer switch box assembly located under the basket.
NOTE: There are two (2) harnesses that connect to the lint drawer switch box. Locate and disconnect the one that leads to the front panel.
5.Pull up the two (2) metal fingers where the door switch harness is secured to the frame and right side panel of the dryer.
6.Remove all nine (9) screws from the front panel. There are four (4) on the left and right sides, and one (1) at the bottom of the panel behind the control door.
7.Gently remove the front panel assembly from dryer.
8.Reverse procedure for reinstalling front panel assembly.
9.Reestablish power to the dryer.
F. To Remove and Replace Lint Drawer Switch Assembly
1.Discontinue power to the dryer.
2.Remove the lint drawer, and the control and lint door from the dryer. Follow lint drawer, and control and lint door removal procedures in sections A and B.
3.If top basket (tumbler) is being serviced, remove the control box assembly. Follow control box removal procedure in section D.
6
