Important
You must disconnect and lock out the electric supply and the gas supply or the steam supply before any covers or guards are removed from the machine to allow access for cleaning, adjusting, installation, or testing of any equipment per OSHA (Occupational Safety and Health Administration) standards.
Please observe all safety precautions displayed on the equipment and/or specified in the installation manual included with the dryer.
Dryer must be installed in a location/ environment, which the ambient temperature remains between 40° F (4.44° C) and 130° F (54.44° C).
“Caution: Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper operation.”
«Attention: Au moment de l’entretien des commandes, étiquetez tous les fils avant de les débrancher. Des erreurs de câblage peuvent entraîner un fonctionnement inadéquat et dangereux.»
Caution
Dryers should never be left unattended while in operation.
Warning
Children should not be allowed to play on or near the dryer(s).
Children should be supervised if near dryers in operation.
Under no circumstances should the dryer door switch, lint drawer switch, or the heat safety circuit ever be disabled.
The dryer must never be operated with any of the back guards, outer tops, or service panels removed. Personal injury or fire could result.
Dryer must never be operated without the lint filter/screen in place, even if an external lint collection system is used.
For Your Safety
Do not dry mop heads in the dryer.
Do not use dryer in the presence of dry cleaning fumes.
Dryer must not be installed or stored in an area where it will be exposed to water or weather.
The wiring diagram for the dryer is located in the front electrical control box area.
Table of Contents __________ | |
Safety Precautions | 2 |
Specifications/Component Identification | 3 |
Specifications | 3 |
Component Identification | 4 |
Installation Procedures | 4 |
Location Requirements | 4 |
Unpacking/Setting Up | 5 |
Dryer Enclosure Requirements | 5 |
Fresh Air Supply Requirements | 6 |
Exhaust Requirements | 6 |
Electrical Information | 8 |
Gas Information | 11 |
Steam Information | 12 |
Preparation For | 15 |
Preoperational Tests | 15 |
Preoperational Instructions | 16 |
Shutdown Instructions | 16 |
Service/Parts Information | 17 |
Service | 17 |
Parts | 17 |
Warranty Information | 17 |
Returning Warranty Card | 17 |
Warranty | 17 |
Returning Warranty Parts | 17 |
Routine Maintenance | 18 |
Cleaning | 18 |
Adjustments | 18 |
Lubrication | 18 |
Procedure for Functional Check of |
|
Replacement Components | 19 |
Data Label Information | 20 |
Manual Reset Burner | |
Phase 7 | 20 |
Dual Timer | 20 |
Fire Suppression System (F.S.S.) | 21 |
