15
SECTION V

PROGRAM SELECTIONS

NOTE: Programs are stored in the computer memory and are cataloged as program locations (PL).

Temperature Display Mode

By closing the Program Switch (PS), the display will read the temperature in the dryer in either Fahrenheit or
Celsius, depending on how the PL01 temperature conversion status is set. The temperature display mode can
be activated while the dryer is in the operating cycle or off. While in the operating cycle, the circuit indicators
are visible for troubleshooting purposes.
NOTE: The dryer cannot be started while the computer program switch (PS) is closed unless the
cycle was already in progress.

Right Coin Count (rCC)

For models equipped with the optional dual coin acceptor, by closing the program switch and pushing the “HI
TEMP” keyboard (touch pad) selection button, the amount of coins inserted through the right coin slot of the coin
acceptor can be viewed through the light emitting diode (L.E.D.) display. The computer memory will retain a
running count of up to 9999 coins and can be cleared (CrCC) by following the program procedure on page 26.

Left Coin Count (LCC)

The number of coins inserted for a single coin acceptor dryer or in the case of a dual coin acceptor, the left coin
slot can be viewed through the L.E.D. display by closing the program switch and pushing the “LO TEMP”
keyboard (touch pad) selection button. The computer memory will retain a running count of up to 9999 coins and
can be cleared (CLCC) by following the procedure on page 27.

PL01 - Temperature Conversion Status

This program controls whether the temperature-related programs will be operated in Fahrenheit or Celsius.
Programs affected are:
1. Temperature display mode
2. Selection cycling temperatures
3. Cool down temperatures

Automatic Mode

When this parameter (“AUtO”) is selected, the dryer will run for a preset level of dryness (PL02) or until the
programmed automatic maximum time (PL14) has expired.