16
At the end of the drying cycle, the dryer will go into the cool down cycle for the time period programmed (PL04,
PL06, or PL08) or until the temperature has dropped to the programmed cool down temperature (PL04, PL06,
or PL08).

NOTE: Due to humidity, atmospheric pressure, percentage of extraction, etc., the desired dryness level

may vary. It is suggested that the owner determine which level of dryness (90% to 100%) is

best suited for his/her application by experimenting with a few test loads.

Timed Mode (tInE)
When this parameter is selected (“tInE”) and the Phase 3 microprocessor controller (computer) has been
activated, the dryer will continue to run until the preset time, including the cool down period (PL04, PL06, or
PL08), has elapsed, at which time the dryer will cycle off or go into the optional Antiwrinkle Program.
Antiwrinkle Program (Grd)
This feature can be used in conjunction with any of the three (3) operating modes (Coin Mode, Auto Mode, or
the Free Dry Mode). In this program (“Grd”), when the drying and cooling cycles are completed, the dryer will
shut off, the tone will sound, and the light emitting diode (L.E.D.) display will read “donE.” If the door is not
opened, the Phase 3 microprocessor controller (computer) will wait until the “Guard Delay Time” (PL15) has
expired, at which time the clothes will be tumbled (without heat) for the programmed “Guard On Time” (PL15).
The Phase 3 microprocessor controller (computer) will repeat the process until the programmed “Active Guard
Time” (PL16) has expired or until the dryer door is opened, at which time the L.E.D. display will read “FILL”
and/or “Amount To Start” (“AtSt”), or “FILL” and/or “FrEE.”
Buzzer/Tone (bUZ)
With the Antiwrinkle Program active, the option is available to have the buzzer/tone (“bUZ”) sound for a period
of 5-seconds at the end of each “Guard On Time” cycle.
Free Dry Mode (FrEE)
The Phase 3 microprocessor controller (computer) can be programmed to run without the insertion of coins.
When the Phase 3 microprocessor controller (computer) is set in the “FrEE” dry mode, it reverts to the “AUtO”
(Automatic) Mode.
Coin Mode (Coin)
In this program (“Coin”), coins are required to start the dryer, even if the Phase 3 microprocessor controller
(computer) is set in the Automatic Mode.
Flash Display Status (FLS)
When the Phase 3 microprocessor controller (computer) is set in this program status (“FLS”), it allows the
L.E.D. readout to display “FILL” (no cycle in progress), and the “Amount To Start” (PL12) or, in the case of
free dry, “FrEE.” The programming allows the L.E.D. readout to flip-flop back and forth every
2-seconds from “FILL” to “Amount To Start,” or in the case of free dry, from “FILL” to “FrEE.”