American International PR 150-34 2NV or 2PV manual Stacking, Water Temperature Regulation

Models: PG10*100-199-3NV or 3PV PR 150-34 2NV or 2PV PG10*50-130-2NV or 2PV PR 130-34 2NV or 2PV PR 100-34 2NV or 2PV PG10*50-199-3NV or 3PV PG10*34-150-2NV or 2PV PR 130-50 2NV or 2PV PG10*50-175-3NV or 3PV PG10*34-100-2NV or 2PV PG10*34-130-2NV or 2PV

1 32
Download 32 pages 44.03 Kb
Page 25
Image 25
Stacking
Figure 22:
Temperature Dial

Stacking

Stacking occurs when a series of short draws of hot water (3 gallons or less) are taken from the water heater tank. This causes increased cycling of the burner and can result in increased water temperatures at the hot water outlet. A tempering valve must be installed in the hot water supply line to reduce the risk of scald injury.

Water Temperature Regulation

Water temperature over 125°F can cause severe burns instantly or death from scalds.

Children, disabled and elderly are at highest risk of being scalded.

See instruction manual before setting temperature at water heater.

Feel water before bathing or showering. Temperature limiting valves are available.

The thermostat is adjusted to its lowest temperature setting when it is shipped from the factory. Water temperature can be regulated by moving the temperature dial to the preferred setting. The preferred starting point is 130°F; however, in some instances, setting the water heater higher than 130°F can reduce the occurrence of igniter failure due to excessive condensate.

Important: A tempering valve (provided) must be installed in the hot water outlet to reduce the risk of scald injury when setting the thermostat in excess of 120°F.

Many home heating systems used with this water heater are designed for temperatures higher than 130°F. Refer to the manufacturer’s instruction manuals supplied with this type of equipment for recommended temperature settings.

Important: Adjusting the thermostat past the 120°F setting on the temperature dial (see figure 22) will increase the risk of scald injury. Hot water can

produce first degree burns within: 120°F (49°C) more than 5 minutes

130°F (54°C) at 20 seconds

140°F (60°C) at 3 seconds 150°F (66°C) at 1-1/2 seconds 160°F (71°C) at less than 1 second

Emergency Shut Down

Important: If overheating occurs or the gas supply fails to shut off, close

the manual gas supply valve. Turn off the electrical supply to the unit and close the cold water supply valve. Do not operate the water heater again until it has been thoroughly checked by an authorized service technician.

25

Page 25
Image 25
American International PR 150-34 2NV or 2PV manual Stacking, Water Temperature Regulation, Emergency Shut Down