American Power Conversion 2200VA 3U, 3000VA 3U PROBLEM AND POSSIBLE CAUSE SOLUTION

1 25

PROBLEM AND POSSIBLE CAUSE SOLUTION

ALL INDICATORS ARE LIT AND THE UPS EMITS A CONSTANT BEEPING

Internal UPS fault. Do not attempt to use the UPS. Turn the UPS off and have it

serviced immediately.

ALL INDICATORS ARE OFF AND THE UPS IS PLUGGED INTO A WALL OUTLET

The UPS is shut down and the bat-

tery is discharged from an extended

outage.

None. The UPS will return to normal operation when the power

is restored and the battery has a sufficient charge.

THE REPLACE BATTERY LED IS LIT

Weak battery. Allow the battery to recharge for at least four hours. Then, per-

form a self-test. If the problem persists after recharging, replace

the battery.

Replacement battery not connected

properly.

Check that the battery connector is fully engaged.

Contents

Main Page 1: SAFETY INFORMATION HANDLING SAFETY LIFE SUPPORT APPLICATION POLICY ELECTRICAL SAFETY DEENERGIZING SAFETY BATTERY SAFETY BATTERY REPLACEMENT AND RECYCLING 2: I UNPACKING POSITIONING THE UPS INSTALLING THE SMART-UPS Page Page Page ACCESSORIES 3: OPERATION INDICATORS AND CONTROLS ON THE SMART-UPS SMART-UPS FRONT PANEL Page Page SMART-UPS REAR PANEL Page ON-BATTERY OPERATION 4: USER CONFIGURATION ITEMS Page 5: STORAGE AND MAINTENANCE STORAGE REPLACING THE BATTERY MODULE 6: TRANSPORTING YOUR SMART-UPS REMOVING THE UPS FROM THE RACK 7: TROUBLESHOOTING PROBLEM AND POSSIBLE CAUSE SOLUTION SERVICE 8: C C REGULATORY AGENCY APPROVALS RADIO FREQUENCY INTERFERENCE DECLARATION OF CONFORMITY LIMITED WARRANTY