5.Connect the battery and attach the front bezel.
6.Connect the equipment and power to the UPS.
7.Turn on the UPS.
INSTALLING THE MOUNTING RAILS IN THE RACK
Install the mounting rails in the rack. Directions are included with the rail kit. The UPS comes with standard
REMOVING THE BATTERY MODULE
The UPS is heavy. To lighten it, remove the battery module before mounting the unit in the rack.
Due to its weight, two people are required to remove the battery module.
The battery module is accessible from the front of the UPS (shown at left).
This procedure requires a Phillips screwdriver.
1. If the UPS has been in operation, locate the white cord Œ attached to the battery module connector plug •. Grasp the cord and pull firmly toward you until the connector plug is disconnected.
|
| • | DO NOT pull the battery module cables. |
|
|
| |
| Π|
| If the UPS has not been in operation, the battery |
|
| will not yet be connected. The UPS ships with | |
|
|
| |
|
|
| the battery disconnected. |
Ž |
|
| 2. Use a screwdriver to remove the two battery |
|
| module mount screws located at the top corners | |
|
|
| |
|
|
| of the face plate Ž. |
|
|
| Set the screws aside in a safe place. You will re- |
|
|
| place them later. |
|
|
| Ž |
5
