Tuner Modules
41
Tango / Mi-Series Audio Controllers
Setting the Jumpers
Mi-Series and Tango Audio Controllers come equipped with one DAS-AMFM Tuner Module, installed into
Slot 2 (see FIG. 57). Mi-Series and Tango Audio Controllers support 2 Tuner Modules in any combination,
this document describes installing the DAS-AMFM Tuner Module into Slot 1, leaving the factory-installed
DAS-AMFM Tuner Module in Slot 2.
Audio Controller Jumpers - Location
Examine the configuration of the jumpers on the left-side Rear-Board Pin Bus, as seen when viewing the rear
board from the front of the Controller (FIG. 58).
Audio Controller Jumpers - ON/OFF Settings
ON position = pins 3 and 2 jumpered (with pin 1 exposed).
OFF position = pins 2 and 1 jumpered (with pin 3 exposed).
Because of the location of the Jumpers in the Controller and on the Tuner Module, it
may be easier to make al l ju mp er se tti n gs bef ore in stalling the Tuner Mo du l e in th e
Controller.
FIG. 58 Audio Controller - Rear-Board Pin Bus / Jumpers
FIG. 59 Controller Jumper Settings
Audio Controller Jumpers rear panel
Rear-Board Pin Bus -
Slot 1 (with faceplate installed)
Slot 2 (with AM/FM Tuner module installed)
(see Fig 4 & 5)
3
1
3
1
Jumper (pins 3-2)
exposed pin (1)
Jumper (pins 3-2)
Jumper (pins 2-1)
exposed pin (3)
Jumper (pins 2-1)
ON position
(Jumper pin 1 & 2)
OFF position
(Jumper pins 2 & 1)
exposed pin (1)
exposed pin (3)