AMX DAS-T0804-SIG Audio Controller Jumpers Dual Tuner Setting, DAS-AMFM Tuner Module Jumpers

Tuner Modules

Audio Controller Jumpers - Dual Tuner Setting

If two tuner modules are to be used, the Audio Controller jumpers should all be set to ON, as shown in FIG. 60:

TUNER 1

Jumpers

TUNER 2

Jumpers

3 1

3 1

Top Left of Rear-Board Pin Bus

3Tuner 1 jumpers (in ON position)

1

3

1 Tuner 2 jumpers (in ON position)

FIG. 60 Audio Controller Jumper Configuration (Dual Tuners)

Move the TUNER 2 jumpers to the ON position by connecting the top 2 sets of pins (pins 3-2) and leaving the bottom pins (pin 1) exposed.

DAS-AMFM Tuner Module Jumpers

There are jumpers on the DAS-AMFM Tuner Module that must be set to differentiate Tuner 1 from Tuner 2 in the Controller.

The instructions for setting these jumpers differ based on the color of the “Interface Board” (red or green), as described below:

Red Interface Boards

Examine the configuration of the jumpers located on the Tuner Modules, to the right of the 20-pin ribbon cable connector (as seen when viewing the installed modules from the front of the controller).

Note that there are two rows of 5 pins as shown in FIG. 61. With only a single tuner, all pins are jumpered.

(no jumpers) Dual Tuners: TUNER 1 Dual Tuners: TUNER 2

FIG. 61 Tuner Module Jumper Configuration (Red Interface Boards)

Green Interface Boards

Examine the configuration of the jumpers located on the Tuner Modules, to the right of the 20-pin ribbon cable connector (as seen when viewing the installed modules from the front of the controller). Note that there are two rows of 5 pins (FIG. 62).

Cable Cable

Tuner 1

Configuration

Jumper

Tuner 2

Configuration

No Jumper

FIG. 62 Tuner Module Jumper Configuration (Green Interface Boards)

Remove all jumpers from the new tuner, and attach the 2-wire (red and white) end of the cable included with your kit to the pins (FIG. 63):

42 Tango / Mi-Series Audio Controllers