AMX DAS-T0804-SIG, DAS-T0808-SIG manual Setting Paging Volume, Room Control Settings

Setup and Configuration

Notes:

Increasing Output Gain will have the effect of increasing the sound level, while decreasing the Output Gain will lower the sound level

Output Gain can be adjusted in increments of 3dB as follows:

0, +3, +6, +9, +12, +15, +18

4.Select “Exit” to set Output Gain for another source.

Paging

Select Paging from the MRC Setup Mode Options screen (FIG. 25) to access the MRC Paging Mode screen (FIG. 30).

FIG. 36 MRC Paging Mode screen

The options on the MRC Paging Mode screen (Page Volume, Room Control) allow you to set the page volume and specify which rooms/zones should be paged.

Setting Paging Volume

1.Select Page Volume to access the Set Paging Volume For All Rooms screen (FIG. 37), where the volume level for paging can be adjusted for all rooms.

FIG. 37 Set Paging Volume For All Rooms screen

Vol. level = 0 – 100 Default volume = 65

2.Select Increase or Decrease to change the volume level as desired.

Room Control Settings

1.Select Room Control from the MRC Setup Mode Options screen (FIG. 25) to access the Set Paging Status For Room screen (FIG. 38), where you can set the paging status of each room/zone.

FIG. 38 Set Paging Status For Room screen

The default status for all rooms is “Paging ON”

Select NextRm to view/change the status of the next room. Select PrevRm to view/change the status of the previous room.

2.Once a room has been selected, select PageOn / PageOff to change the status for that particular room.

32 Tango Series Audio Controllers