AMX FG147-04 manual Setting The IR Frequency, Debug Mode, Battery Type, LED Awake Brightness

Programming The MIO R-1 AUDIO

Debug Mode

Pressing button "4" on the remote toggles development mode between ON and OFF. The display indicates the selected mode. In development mode, the display shows the IR code assigned to buttons when pressed.

This mode is useful to the programmer when determining what IR codes are associated to each mode.

Battery Type

Pressing button "6" on the remote toggles the battery type between Normal and Recharge. The display indicates the selected type. The type of battery in the MIO R-1 AUDIO dictates the battery type you need to set.

LED Awake Brightness

Pressing button "7" on the remote toggles the Power LED brightness mode from LOW to MED and then HIGH. The display indicates the selected mode.

Sleep Brightness

Pressing button "8" on the remote toggles the Sleep brightness mode from OFF to LOW and then MED. The Sleep brightness is the state the MIO R-1 AUDIO assumes while in the charging cradle.

Setting The IR Frequency

The MIO R-1 AUDIO is set to the IR frequency 38KHz by default. You need to utilize the IRMODE Serial Command to change the frequency to 455KHz. To set the frequency to 455KHz:

1.Establish a HyperTerminal session with your device.

2.Send "IRMODE 455" to the device.

3.Close the HyperTerminal session.

The command, "IRMODE 38" switches the device back to 38KHz.

8 MIO R-1 AUDIO