AMX MAX-AVM manual Connecting the MAX-AOM to the MMS Server

MAX-AOM Audio-Only (USB) Module

If you are adding only one AOM module to the server, then you’ll specify up to four server output/zones (one for each of the four possible audio outputs on the AOM). If you are adding two AOMs (MMS-04S, -12S and -900 servers only), you’ll specify up to eight outputs (four per AOM), as indicated in the following table.

MMS Output Zones, USB Port and AOM Audio Outputs

MMS Output/Zone (1-33)	USB port connection (1-2)	AOM Audio output (1-4)
1	AOM 1 (on USB 1)	AOM 1 - Audio Output 1
2	AOM 1 (on USB 1)	AOM 1 - Audio Output 2
3	AOM 1 (on USB 1)	AOM 1 - Audio Output 3
4	AOM 1 (on USB 1)	AOM 1 - Audio Output 4
5	AOM 2 (on USB 2)	AOM 2 - Audio Output 1
6	AOM 2 (on USB 2)	AOM 2 - Audio Output 2
7	AOM 2 (on USB 2)	AOM 2 - Audio Output 3
8	AOM 2 (on USB 2)	AOM 2 - Audio Output 4
9	AVM 1
10	AVM 2
11...(to 33)	AVM 3...

4.In the Enter USB port number field, enter the number of the USB port on the MMS server that this AOM will be connected to (range = 1 - 2). If you are using a MMS-01S, -02S or -02SB server, this number should always be set to 1 (since these servers have only one USB port). Click OK to proceed.

5.In the Enter AOM output number field, specify which of the four available audio outputs on the AOM you are adding (range = 1 - 4) to the MMS server output number specified in step 1.

6.The system will notify you that the module has been added to the system. Click OK to return to the Output Module Setup menu.

Once the module has been added, select View from the Output Module Setup menu. The module you just added should appear in the list of Installed Output Modules. AOM modules are listed by MMS output / zone number assignment, USB port number and AOM output number.

Select View from the Admin menu to view a list of all output modules (AOMs and AVMs) already in the system.

Select Remove to remove an existing output module from the system.

Connecting the MAX-AOM to the MMS Server

Once the AOM has been added to the server, you can connect it to the MMS server and audio system(s):

1.Connect the AOM(s) to an audio system (amplifier, switcher, etc.) using one of two options:

a.Use stereo RCA cables for analog audio output.

b.Use a coaxial cable for digital audio output.

2.Connect the included power supply to the rear panel power connector on the AOM to apply power to the module.

3.Use the supplied 6’ USB cable to connect a USB port on the rear panel of the MMS server to the USB port on the rear panel of the MAX-AOM module.

MAX AOM and AVM Modules 5