Antunes, AJ MS-250/255, MS-355 owner manual Installation, Only, 208 VAC, Miracle Steamer

MIRACLE STEAMER

A.J. Antunes & Co.

INSTALLATION

Unpacking

1.Remove unit and all packing materials from ship- ping carton.

2.Open the large box. It should contain the follow- ing:

•Miracle Steamer,

•Handle, Handle Guard & Shoulder Bolt, (MS-150/250 only)

•Water Hookup Kit (MS-250 only).

NOTE: If any parts are missing or damaged, contact Antunes Technical Service IMMEDIATELY at 1-877-392-7854or 1-630-784-1000.

3.Remove all packing materials and protective cov- erings from the unit.

4.Remove and wash all removable parts in soap and water. Rinse with clean hot water and allow to air dry.

5.Wipe all surfaces of the unit with a hot damp cloth.

NOTE: Do not use a dripping wet cloth. Wring out before use.

6.MS-150/250 Models: Assemble the handle, han- dle guard and mounting bolt to the spatula as shown in Figure 1.

7.Re-install all removed parts.

Equipment Setup

GENERAL

When placing the unit into service, pay attention to the following guidelines:

•Make sure power to the unit is off and the unit is at room temperature.

•Do not block or cover any openings on the unit.

•Do not immerse cord or plug in water.

•Keep cord away from heated surfaces.

•Do not allow cord to hang over edge of table or counter.

ELECTRICAL

1. Place the unit on a sturdy, level table or other

Bolt

Guard

Handle

Spatula

Figure 1. Assembling Handle–MS-150/250 Only

work surface. Turn the rocker switch (power ON/OFF to OFF before proceeding.

2.Ensure that the line voltage corresponds to the stated voltage on the units specification label and power cord warning tag.

3.Connect the unit to the power supply.

THIS APPLIANCE MUST BE	THIS APPLIANCE MUST BE
EARTHED GROUNDED	EARTHED GROUNDED

THIS UNIT IS DESIGNED TO OPERATE

ON 120 VOLTS ONLY. APPLICATION 120 VAC WITH ANY OTHER VOLTAGE SUPPLY

COMPLETELY VOIDS ALL WARRANTY. ONLY PLEASE CHECK YOUR LINE VOLTAGE BEFORE INSERTING THIS PLUG INTO

THE RECEPTACLE.

	THIS APPLIANCE MUST BE		THIS APPLIANCE MUST BE
	EARTHED GROUNDED		EARTHED GROUNDED
208 VAC		THIS UNIT IS DESIGNED TO OPERATE
		ON 208 VOLTS ONLY. APPLICATION
		WITH ANY OTHER VOLTAGE SUPPLY
	ONLY	COMPLETELY VOIDS ALL WARRANTY.
		PLEASE CHECK YOUR LINE VOLTAGE
		BEFORE INSERTING THIS PLUG INTO
		THE RECEPTACLE.
	THIS APPLIANCE MUST BE		THIS APPLIANCE MUST BE
	EARTHED GROUNDED		EARTHED GROUNDED

	THIS UNIT IS DESIGNED TO OPERATE
	ON 220-240 VOLTS ONLY. APPLICATION
220-240 VAC WITH ANY OTHER VOLTAGE SUPPLY
ONLY	COMPLETELY VOIDS ALL WARRANTY.
	PLEASE CHECK YOUR LINE VOLTAGE
	BEFORE INSERTING THIS PLUG INTO
	THE RECEPTACLE.

6 P/N 1010699 Rev. B