MIRACLE STEAMER
A.J. Antunes & Co.
Model MS-250/255
The
1.Connect the 1/4" (6.5 mm) I.D. flexible tubing to your cold water line using the supplied hose clamp.
2.Push the quick disconnect insert into the fitting on the back of the unit (Figure 4).
NOTE: Incoming water is controlled by a solenoid valve inside the electrical housing of the steamer.
CAUTION 
Water pressure must not exceed 25 psi (1.7 kg/cm2 or 172 kPa). Higher water pressures may cause poor performance or flooding. To reduce water pressure, install a water pressure regulator, and set water pressure to 20 psi (1.4 kg/cm2 or 138 kPa). To order a water pressure regulator from your authorized service center, order Roundup part no. 7000235.
Water Connect FittingQuick Disconnect Insert
Power Cord
Figure 4. Connecting Water Supply to MS-250/255
OPERATION
General
When the operate button (Figure 5) is pressed, power is supplied to the water pump
One of two operational modes can be used: Single Shot or Timed Cycle
SINGLE SHOT
The operate button is pressed to initiate a single timed shot. The control board applies power to the water pump/solenoid and a timed “shot” of steam occurs.
TIMED CYCLE
The control is set to the desired cook time (up to 99 minutes, 59 seconds), then the Start/Stop Button is pressed. The main control board applies power to the water pump/solenoid at regular intervals for the dura- tion of the displayed cycle time. The display counts down to zero when the cycle is complete sounding a audible signal then reverts back to the original pro- grammed cycle time. The unit is ready for the next cycle when the green ready light is on.
Ready Light
READY
|
|
| Message |
|
|
| Display |
|
|
| Start/Stop |
UP | DOWN | PROGRAM START/STOP | Button |
|
|
| Operate |
|
|
| Button |
|
|
| Rocker Switch |
POWER |
|
| (Power On/Off) |
Figure 5. Operating Controls
8 |
| P/N 1010699 Rev. B |
|
|
|
|
|
|
